Shaun's FotoPage

By: Shaun Acosta

[Recommend this Fotopage] | [Share this Fotopage]
View complete fotopage

Tuesday, 20-Dec-2011 08:49 Email | Share | Bookmark
Make A Canine Tag

Components AND Equipment
  • A Personal computer, printer, and white or colored paper or black pen and paper
  • Any form piece of blank steel or plastic with rounded edges amongst 1 x one inches (25x25 mm) and 1.5 x 2 inches (38 x 50 mm) with a small hole in it
  • A metal ring to attach the tag to the collar
  • Some epoxy (desired) or other very good glue that dries clear
  • A thoroughly clean plastic lid
  • A piece of waxed paper
  • Scissors
  • A knife or screwdriver to spread the epoxy
  • A toothpick or pin
\nPlanning THE Information
  • Choose what data you want on the tag
  • If making use of a laptop or computer, use small font measurements (we utilised Instances New Roman sizes 5 to nine) and try several combinations of info on a single sheet of paper before printing
  • If writing by hand, place the pet dog tag beneath your paper and outline the area to publish in before adding the info
  • Minimize all around the place with scissors and see how it fits on your dog tag
  • Do last trimming as necessary and put the piece of paper in a risk-free location \nGLUING ON THE InfoNote: Make sure you remember to comply with all maker recommendations relating to the use of epoxies, glues, or resins and especially to use these chemical compounds in a nicely-ventilated location.
  • Clean and dry the tag totally so it will take the glue effectively
  • Blend a modest quantity of epoxy on the plastic lid
  • Utilize epoxy evenly to the back of your piece of paper to soak it in
  • Following the paper is a uniform colour, carefully area it on the tag
  • Slide it all around as necessary to place it exactly where you want it
  • Tamp the paper down flat to avoid bubbles
  • Mix up a lot more epoxy to cover the tag about one/ten inch (1mm) deep
  • Distribute the epoxy all the way out to the edge to make a excellent seal \nDRYING \n
  • Set the tag aside to dry on a piece of waxed paper in a dust cost-free place - This may consider a number of hours on a heat, breezy day. If it really is cold out, consider to dry close to a warm indoor resource or wait a number of times
  • Make sure your canine has some other sort of identification or is closely supervised whilst the tag is off the collar
  • When partially dry, poke excessive epoxy out of the hole necessary for the steel ring
  • When fully dry, slip the ring via the tag and attach it to your dog's collar \nWe produced a tag like this for our pet dog, Comet, around a year back. The data is nevertheless fully readable and the epoxy has not chipped off.Dog Id Tags\nRelated Sites : dog id tags


  • View complete fotopage


    © Pidgin Technologies Ltd. 2016

    ns4008464.ip-198-27-69.net